The conversion kit is completly prepaired for the most simple mounting possible into the viewers. A easy step-by-step documentation with a foto for each step is included on CD.

The additional electronic board contains a new motor control with powerful, load-independend drive.

After conversion, the viewer will provide an accurate output for electronic frame number counting, foreward and backward. This is very helpful to complete your story board with the characteristic frame numbers, where are scene changes or special sound events to be recorded. The connection to the counters C1008, C1008-D is done by a 6pin DIN connector mounted into the case of the viewer. For frame counting, the viewer can be used hand cranced or with the internal motor.

The included 8pin DIN connector enables the connection to the synchronizers P1008 and P1008-Q. After selecting the frame rate range at the viewer (selector included in the kit), it will run, start and stop just like a projector according to the sync signal connected to the synchronizer.

This enables you, to edit sound on perforated tape and view the film in sync with your tape at any time. The viewer will simply follow the moving tape reels just like a well educated dog.

Of course, some wire must be soldered to the motor control board of the viewer. The included manual shows exactly how to do this. You will need a pen-type soldering iron and electronic soldering wire, the most cheapest model will fit.